Precision requirements for the manufacturing of storage shelves

　　A. Column:

　　(1) The cumulative error of the total length adjustment hole spacing of the column shall not exceed 2mm, and the error of adjacent hole spacing shall be less than 0.02mm;

　　(2) The maximum deviation of the total length dimension of the shelf shall not exceed 2mm;

　　(3) The bending error of the column sheet is less than L/1000 mm and not more than 6mm;

　　(4) The vertical deviation between the column and the installation ground is less than L/1000mm and not more than 6mm;

　　(5) The maximum deviation of shelf width is less than 1mm;

　　(6) The maximum deviation of the height difference of the shelf bottom plate is less than 0.5mm;

　　B. Cross beam:

　　(1) The error in the length dimension of the crossbeam is less than 0.5mm;

　　(2) The height error at both ends of the crossbeam assembly is less than 1mm;

　　(3) When the shelf crossbeam reaches the required maximum load-bearing capacity, the deformation of the crossbeam should be less than L/250.

　　C. After the overall installation of the shelf, it should comply with:

　　(1) The verticality of the shelf pieces along the length and width direction of the roadway is less than 10mm;

　　(2) The allowable deviation in the width direction of the roadway is less than 5mm.

Read recommendations:

6-Tier Metal TV Stand For 42 Inch TV/ Entertainment Center / TV Console Table With Open Storage Shel

3 tier wire shelving unit Factory

Shelf design should also pay attention to the following points.garage storage shelving unit